SERVICE STATION SVS-800AS
Omnifunctional machine for soldering,
desoldering and reworking.
The temperature can be set to max 550°C.
Good for a wide range of soldering work with 70W heater.
Instant desoldering with open-valve mechanism.(Please refer to the next page.)
INDIVIDUAL POWER SWITCHES
Along with the main power switch, there are switches for soldering, desoldering, and reworking.
Desoldering and reworking operate simultaneously
400% More Suction Capacity
With open-valve mechanism
Ceramic Heater with Internal Sensor
A wide range for terminals, connectors and flat ICs (soldering & desoldering)
Superior Temperature-Control Circuit
To keep the temperature constant during desoldering
Zero Volt Switch Circuit
Reduces noise during heater ON/OFF
Two-stage trigger switch (PAT.P)
Pulling the trigger (lightly) activates the first stage switch. The pump starts, and the air pressure decreases in the vacuum chamber.
Next, pulling the trigger fully activates the second stage. The open-valve will open, and the solder is sucked up at once by the negative pressure in the vacuum chamber.
Replaceable Cartridge Filter
Makes changing the filter easy
TIP/NOZZLE TEMPERATURE-RECOVERY FEATURES
Desoldering/Soldering time is approx. 2 seconds / 5×5mm land (with PX-2RT-B tip, TP-100N-10 nozzle)
Vacuum pressure compared with other goot models
The open-valve allows the device to reach vacuum pressure of -0.06MP (approx.-450mmHg) in only 0.1second. (about 4 times faster than our SVS-500AS).
SUCTION CAPACITY COMPARISON
The arrow indicates solder residue.
Soldering Iron Unit SVS-800AS, SVS-580AS, SVS-500AS
Soldering Iron Unit SVS-800AS, SVS-580AS, SVS-500ASs
|Voltage||220-240V AC 50/60Hz|
|Power Cord Length||1.5m Inlet type|
|Temp. Setting Range||Desoldering Unit||250−450°C|
|Insulation Resistance||Over 10MΩ(500V DC)|
|Vacuum Pump System||Diaphragm system|
|Vacuum||– 0.08MPa (-600mmHg)|
|Air Flow||5-25L /min|
|Accessories||Cleaning pin TP-100CP-13 / Soldering iron stand ST-76|